Stretch ceilings are made of special vinyl film that is stretched on a plastic frame. This frame may be visible or hidden. There are many types of performance outside of the stretch ceilings, such as suede or imitation marble, lacquered or matte, as well as a variety of colors. Plus, the ceilings have many advantages, here are a few: – If the ceilings contaminated, they easily wash off with plain water – for long term use such ceilings are not cracked or damaged from shock – Stretch ceilings are very thermally stable, they retain their excellent properties at temperatures -5 to 50 degrees – Because the ceilings are made of special vinyl, they meet all international standards for fire safety in fire they do not burn and do not melt – If there is leakage in the ceilings, then ceilings stand about 100 liters of water per 1 square meter. And after you remove the vinyl itself restores water tension.
Water is removed very easily, it is enough to open a hole for the lamp, but if the built-in ceiling lamps are not available, then you need to call a specialist with the firm that you mounted the ceiling, coming just a specialist otognet one corner and will merge the water, then set the angle back – Thanks to the plasticity vinyl, ceilings can be installed in absolutely all areas in different planes, to make different slopes, in general, anything that pleases you – Plus manufacturers, such ceilings give ten-year warranty. How is the mounting tension ceilings? Quite simply, workers measure the space in which to mount the ceilings, then made to get the size of a vinyl film with the frame. Once you are ready to be mounted on the perimeter of a room attached plastic frame, which will attach itself Vinyl. The frame is fixed at 5 cm below the main ceiling. Next Vinyl film is attached to the frame at the corners, with special clips. After that, the room is heated by means of special equipment.
When the room was warmed begins assembling the ceiling. After mounting the film in a room air slowly cools, and the film tension ceiling stretched itself. The width of a vinyl film is usually equal to 1.4 m, so there will be joints, welded joints but these, as will be seen by only a very thin line on the spot connections, and if the matte film has been used, this joint is generally not noticeable. Because the ceilings have good fire resistance they can mount any lights with incandescent lamps 60 W and halogen lamps up to 35W. Lamps themselves are fixed to the main ceiling, stretch ceilings in a light-drilled holes, which pass through the ring. That is why the ceilings are the most inexpensive, beautiful scenery and convenient method of any premises.